QRP Station > Transceivers

HW-7 mods

<< < (2/3) > >>

KC8AON:
Anything would be better than original on an HW-7 - the one I had was horrible on receive!

N8XEE:

--- Quote from: KC8AON on January 22, 2015, 13:34:00 UTC ---Anything would be better than original on an HW-7 - the one I had was horrible on receive !

--- End quote ---

It's actually no worse than any other DC receiver...  The sensitivity is just fine.  It's the selectivity that's a problem, as it's very wide.  The easiest (and least invasive) mod is to add an outboard audio filter between the rig and your headphones.  Mine has 6 steps that go from 2,500 Hz down to about 100 Hz.  I usually run it around 400Hz, which is plenty narrow for all but the most crowded band conditions.  The Four State QRP Group sells a kit for about $20.  It has a 50dB notch at 200Hz.  There are other kits that range from about the same up to just under $100.  Well worth the money.

WB3T:
I think the HW-7 has gotten a bad rap. Mine works fine with a few simple mods and an outboard audio filter. Rebuilding the whole receiver section is NOT necessary! Here's mine with a DSP unit, but the Four State SCAF filter does just as well.

https://www.youtube.com/watch?v=EpPGC2XQT4A

A description of the mods can be found here: http://radiowb3t.homestead.com/heathkit.html

Good luck!
Bob, WB3T

F5MPN:
Hello

I ask you a simple question regarding the bias of the diode. Is it in passing or reverse (biased) mode. If you could give me a little more information.
Best Regards

F5MPN St├ęphane

ac9xh:
I love the hw-7 and hw-8
so if anyone here has one to get rid of let me know. I have several articles on mods for both these rigs

73
David
ac9xh

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version